日本在线天堂-日本在线视频一区二区-日本在线视频一区-日本在线视频网址-日本在线视频网站www色下载-日本在线视频网

Welcome toZhejiang Yuman Electric Technology Co., Ltd.Official website, we focus on the production and sales of high-quality fans!

Tel:86-15068298836 / 13868374889

Home / News / Commonly problematic parts of stainless steel fans

Commonly problematic parts of stainless steel fans

date:[2021-02-24]     pk_hits:

The stainless steel fan is simply a kind of equipment for conveying gas, and its composition is not complicated. Stainless steel fan installation preparation


The main parts of a stainless steel fan are: impeller, volute, air inlet, bracket, motor, pulley, coupling, muffler, transmission (bearing), etc.


After the stainless steel fan is used for a long time, some parts will have problems under the influence of external factors or its own material factors.


Today, I will introduce to you which parts often have problems.


1. Gear


When designing the gear of the stainless steel fan, a certain amount of tooth wear is calculated. During normal use, its wear is negligible.


If the oil level in the gear box is high, it will cause too much oil to heat up during agitation, and the temperature at the bottom of the oil tank will be too high.


If you continue to operate in this situation, the gear will heat up and the gear may be affected by rapid wear, which will cause the impeller blades to contact or the unit to jam.


2. Bearing


The service life of the booster is closely related to the bearing.


Gradual wear may change the position of the shaft until friction occurs between the impeller and the cylinder block or top plate, and sudden bearing failure usually has serious consequences.


Because the impeller shaft assembly is no longer supported and correctly positioned, extensive damage to the casing and gear may occur immediately after the bearing fails.


3. Transmission shaft sealing components


The assembly is composed of two independent lip seals immersed in oil and located in the drive end cover.


If the oil level of the oil gauge rises, it means that the oil leakage through the inner member is excessive, and it should be replaced as an assembly.


Unless the seal or its bearing surface is damaged, the possibility of leakage through the outer member is unlikely.


In addition, the smoothness of the shaft also has a considerable influence on the performance of this type of seal. The operation problem may be caused by reasons other than component damage.


Since the gap is only a few thousandths of an inch, installation changes or pipe support changes may cause interference and friction.


Four, casing


Foreign matter entering the stainless steel fan casing can also cause some trouble.


If you encounter this type of problem, but you find that the inside of the casing is clean, please disconnect the pipe and loosen the mounting bolts, and re-level and align the driver.


After tightening the installation, make sure that all pipes are properly connected to the unit before reconnecting.


The above is the introduction about the problems with stainless steel fan parts. You must check and maintain it regularly during actual use.


Focus on the production of electrical equipment series products

Contact Us

If you have any questions, suggestions and products you want to know, you can contact us at any time. Looking forward to your consultation?

message

主站蜘蛛池模板: 久久久久久久综合色一本| 国产一级特黄aa级特黄裸毛片| 又色又爽又黄高潮的免费视频| 黄色 在线| 男女啪啪永久免费观看网站| 日韩a免费| 亚洲av成人无码一二三在线观看| 伊人网大香| 国产精品无码av在线播放 | 日本巨大的奶头在线观看| 国产美女视频黄a视频全免费网站| 久久草草亚洲蜜桃臀| 97国产婷婷综合在线视频| 免费a级毛片无码无遮挡| 亚洲精品一区二区国产精华液| 久久精品人人做人人爽电影蜜月 | 在线观看国产一区二区三区| 成人精品人成网站| 日本高清视频www| 精品无码人妻被多人侵犯av| 风韵多水的老熟妇| 国产男女性潮高清免费网站| 麻豆三级在线播放| 伦伦影院午夜理论片| 欧美顶级少妇做爰hd| 五级黄高潮片90分钟视频| 无码不卡中文字幕av| 久久瑟| 精品熟女少妇av免费观看| 免费a级毛片无码免费视频| 狠狠躁| 熟女少妇内射日韩亚洲| 国内精品一区二区三区| 色成人免费网站| 亚洲av无码精品色午夜app| 久久精品日日躁夜夜躁欧美| 日韩欧美国产电影| 久久综合精品国产一区二区三区无码 | 亚洲日本天堂在线| 欧美福利精品| 亚洲精品无码mv在线观看|